Slide Master to MINESC Calibration is now complete, however you must test that it has worked corectly.Īrm copter, and all motors should spin at 0 throttle. Unplug batterySlide Master to MAXPlug in battery, wait for beeps. remember, you should have removed props at the start, if you didnt, DO THIS NOW. Green = mode activated, grey means Acro/Rate mode.Now we need to calibrate ESC, go to the motor tab. If you have more than six channels you may want to setup ARM as a switch, as well as a buzzer, or lights.Now save your settings.īy moving your switches you should be able to test the setup. You want to set up your AUX Switches, open the Modes Tab.No mode selected = ACRO+ / Rate mode by default.Altitude mode = Angle Mode Rattitude mode = Horizon Mode If you your switch only has two positions it would look something like this.0 = Horizon Mode 1 = Acro/RateIf you have a switch that has 3 positions it may look like this.
Open cleanflightPower your Quad and plug usb back in now.IMPORTANT! Leave USB plugged in and power the board via esc inputClick boot (in same firmware window), motors will beep and wait till blue light on the cc3d is steadily blinking.Click the checkbox, I know what I’m doing!.Click rescue then plug in your Quad to computer via USB (no power)Click open and select.On openpilot and open the firmware tab.For difference on Cleanflight vs Betaflight view this article.bin file – so thats why we have put Cleanflight 1.10 ONLY, versions after this do not have. bin or Latest Betaflight CC3D BIN File from
Install the Cleanflight Configurator from the Chrome Web Store.Download Cleanflight 1.10 firmware.
Download OpenPilot GCS 15.02.02, You may also need the STM32 Virtual Com Port driver.If, you flip the cc3d board you can see a micro usb connection on the cc3d.After connecting the usb to your pc, it might ask you to download drives,then do it.